User Manual

Getting Started
Quick Start
23
© 2017 REXING A ll Righ ts Re s er v ed .
• If the battery is completely discharged, the device will not turn on
immediately when the charger is connected. Allow a depleted battery
to charge for a few minutes before attempting to turn on the device.
• The device can be used while it is charging, although it may take
longer to fully charge the battery.
• If the device receives an unstable power supply while charging, the
screen may not function properly. If this happens, unplug the charger
from the device.
• While charging, the device may heat up. This is normal and should
not affect the device’s performance or lifespan.
• If the device is not charging properly, take the device and the charger
to an authorized Rexing Service Center.
Connecting the charger improperly may cause serious damage to the
device. Any damage caused by misuse is not covered by the warranty.
Inserting the memory card
Note: All micro SD cards have a limited life span of being rewritten about 500
times. For 32GB memory card you will need to replace your micro SD card after
3,000 hours of use to prevent any freezing issues or corruption of the card or
videos.
If you are using a high endurance micro SD card this life span goes up to 2,000
times being rewritten. You will need to replace it after 12,000 hours of use to
prevent any freezing issues or corruption of the card or videos.