User Manual

1. Hold the button to enter the repeat alarm setting mode, the tens of the hour

starts to flash, and the alarm symbol flashes.

2. Use the and buttons to adjust the time.

3. If no button is in operation for more than 10 seconds when any number is flashing,

the setting edit will be canceled, and the current setting data will be invalid. If you

re-press any button, the Time Setting will restart.

Alarm Setting

Non-repeat Alarm:

Repeat Alarm

(hour/minute adjusment)

1. Hold the button to enter the Non-repeat alarm setting mode, the tens digit of

the hour and the alarm icon will start to flash.

2. Use the and buttons to adjust the time.

3. If no button is in operation for more than 10 seconds when any number is flashing,

the setting edit will be canceled, and the current setting data will be invalid. If you

re-press any button, the Time Setting will restart.

4. When the hour adjustment is complete, press the button again to enter the

setting of the next digit; when the hours and minutes have been set, press the

button again to confirm which will follow by a long beep sound. When the alarm

clock symbol lights up, it means that the single alarm setting is successful.

5. When the time of the non-repeat alarm is triggered, the alarm icon is always on. The

buzzer will also intermittently beep, light up, and flash simultaneously. After 1

minute, the buzzer will stop automatically, and the light and the alarm clock icon will

go out. If any button is pressed during the alarm period, it will end immediately.