User's Manual

7
For the rearview camera, there are two wiring options as shown in the above
figure. The first part of both options is characterized with concealed wire
routing against the edges of the door(s).
A: The rearview camera can be mounted directly above the rear window
inside the car.
B: The rearview camera can be mounted directly above the car’s license
plate.
We recommend that you install all components beforehand according to the
above drawing and test the system by using the on-board charger power
supply. Make sure the device is good condition prior to installation. Please,
contact our service center in case of any questions.
Note: The device is configured with a streaming media rearview camera that
provides clear traffic view behind the car. To obtain clearer and more
intuitive images, it is recommended to mount the camera above the license
plate (as shown by option B).
7. Instructions for Reverse Trigger Wiring
The red wire of the car’s reverse gear wiring is connected to the positive end
of one of the car’s reverse light. Make sure that the car charger is energized
during use.
III. Turn on the Dash Cam
Connect the dash cam to the car charger after installation. Starting the car
engine will start the device. The built-in battery will be charged at the same
time.
Note: Due to unstable voltages caused by starting the car engine, a voltage
fluctuation in some vehicles may be especially obvious. If a flashing screen
or some other unforeseeable operating problem occurs when you start the
engine, it is recommended to unplug the device from the charger before
starting the engine, and then reconnect it after the engine is running.
Re
d