User Manual

Due to excessive mishandling, this device could be damaged during
transportation. To avoid high cost of troubleshooting and repairs due to repeated
mounting and removal, we recommend that you assemble all components first
after delivery and test the device with the on-board charger power supply. Make
sure that the device is visibly undamaged prior to installation. Contact our service
center in case of any questions.
I. Install the Device
Turn off the engine of the car.
Place the MicroSD card into the slot.
Secure the dashcam to the original rearview mirror of the car.
Plug the GPS module into the GPS port and secure the module to a position close
to A-pillar of the car. The antenna receiver side (the side without 3M adhesive)
faces the outside and the side with 3M adhesive faces down. It should be
properly secured.
Plug the charger into the car’s cigarette lighter and connect it to the dash cam’s
USB port with the included extended USB cable.
8
Installation
!
2.
3.
The optional rearview camera is mounted on the rear of the car. Pay attention to its
orientation during installation. Plug the rearview camera connector into the
corresponding port of the dashcam once the installation is completed. Adjust the
position of the lens to ensure that it aligns horizontal with the ground. Start the
engine to check the video functionality of the device.
4.
5.
Note:
1.