User Manual

22
Warning Sensitivity
High
Moderate
Low
Car
Warning
Speed
Warning
Sensitivity
18:03
12-05-2019 Thursday
BSD setup
5. Move the red line up or down to the horizon (the intersection line between sky
and Earth). Move the yellow line up or down to the interface between the car’s tail
and ground. Move the green line left or right to the focal point where the far end
road intersects with the horizon. After proper adjustment, click Next to access
calibration of the warning range.
4. Click to access the BSD calibration interface. You will initially see the concept
and a brief introduction on the calibration page. Click Next to access the real
calibration interface, as shown below:
BSD Calibration
The red line is the horizon, which
should be moved to the interface
between sky and ground. The green
line is the central axis, which should be
moved to the focal point where the far
end of road intersects with the
horizon. The yellow line is car’s tail line,
which is to be moved to the interface
between car’s tail and ground.
18:03
12-05-2019 Thursday
Next