User Manual

15
Reset setting
Select Yes and press OK to restore all
parameters to the original factory default settings.
Camera Operation
Aligning The Camera
In TEST mode you can work out the optimum
exposure angle and the range of the motion
sensors.
During alignment, consider whether the use
of the side motion sensors may be useful for
attaining the desired observation results. You can
activate/deactivate the side motion sensors using
the above-described menu,
Align the camera as follows:
Fasten the camera to a tree or similar object at
a height of 3-6 feet and align the camera in the
desired direction. Then move slowly from one
side of the target area to the other side. While
doing this, monitor the motion display.
• If this lights up in blue, you have been
detected by one of the activated side motion
sensors, If it lights up in red, you have been
detected by the front motion sensor. This
way, you can work out the best alignment for
the camera.
The motion display only lights up when the
operating mode selector switch is in the SET
position and one of the motion sensors has
detected movement. During normal operation,
there will be no LED display.
To ensure that the camera does not record
unwanted recordings of relevant movements,
it should not be set up in a sunny location or
close to branches that can move in the wind. The
recording angle of the sensors is about 100°
from corner to corner; and the recording field for
photos and videos are around 89°.
CAMERA IS READY TO USE - Switch
to ON
AFTER CHANGING TO DESIRED SETTING and
SIMPLY SLIDING SWITCHES TO ON POSITION, the
camera is in active standby mode and will record
media according to the switch settings.
Firstly, the motion indicator LED will blink
red for about 15 seconds. Any motion is
detected by the side PIR sensor; the camera
will be active without trigger. As soon as the
further motion is detected by the central
PIR sensor within 5 minutes, the camera will
take photos or videos. Otherwise, the unit
will return to standby state.