User Manual

10
Installation
Power Supply
Batteries Installation
Open the camera by unlocking the latch firstly.
The battery compartment is the right part of the
camera. Open the battery cover and
insert 8x1.5v LR6/AA batteries (or NI-MH
rechargeable batteries) into the battery slots.
Make sure to insert each battery with correct
polarity (+ and - end against the long spring of
each battery slot).
Using an External Power Source
Optionally, you can connect an external 6V DC
power source with at least 1.5A to the port ‘DC
In’ port at the bottom of the camera. The
power connector is a 3.5x1.35 mm coaxial DC
power plug with positive ‘tip’ (inside pin)
polarity. Leave internal batteries in the camera
during use.
• Insert the SD card into the card slot. A "click"
sound indicates that the card is installed
successfully. If the wrong side of the card is
facing up, you will not be able to insert it
without trying to force it in. There is only
one correct way to insert the SD cards.
• To take out the SD card, just gently push in
the card (do not try to pull it out without
pushing in first). The card is released from
the slot and ready to be removed when you
hear the "click" sound.
Inserting the SD Card
The camera uses a Micro SD (Secure Digital)
memory card to save photos (in jpg format) and/
or videos (in .AVI format). SD and SDHC (High
Capacity) cards up to a maximum 32GB capacity
are supported.
Insert the SD card (with the camera’s power
switch in the OFF position) before beginning to
operate the camera. Don’t insert or remove the
SD card when the power switch is in the ON
position.
Note:
Note:
• NEVER INSTALL DIFFERENT TYPES
OF BATTERIES or NEW AND OLD
BATTERIES in the product at the
same time.
• Anytime you load or unload
batteries, make sure that the
camera is OFF. If using external
power source, do not remove
internal batteries.
• Be sure the camera’s power is
switched OFF before inserting or
removing SD cards or batteries.
• Camera will not operate without a
memory card installed.