User manual

Problem Possible cause Solution
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The "FastFreeze or "Fast‐
Cool is switched on.
Refer to "FastFreeze function"
or "FastCool function".
The compressor does not
start immediately after
pressing the "FastFreeze or
"FastCool, or after changing
the temperature.
This is normal, no error
has occurred.
The compressor starts after a
period of time.
Water flows inside the refrig‐
erator.
Food products prevent the
water to flow into the wa‐
ter collector.
Make sure that food products
do not touch the rear plate.
The water outlet is clog‐
ged.
Clean the water outlet.
Water flows on the floor. The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
Attach the melting water outlet
to the evaporative tray.
Temperature cannot be set. The "FastFreeze function"
or "FastCool function" is
switched on.
Switch off "FastFreeze func‐
tion" or "FastCool function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"FastCool function".
The temperature in the ap‐
pliance is too low/too high.
The temperature regulator
is not set correctly.
Set a higher/lower tempera‐
ture.
The door is not closed cor‐
rectly.
Refer to "Closing the door".
The food products' tem‐
perature is too high.
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Many food products are
stored at the same time.
Store less food products at the
same time.
The door has been
opened often.
Open the door only if necessa‐
ry.
The "FastFreeze function"
or "FastCool function" is
switched on.
Refer to "FastFreeze function"
or "FastCool function".
There is no cold air circu‐
lation in the appliance.
Make sure that there is cold
air circulation in the appliance.
13