Instruction Manual

7www.rexnordic.uk
Remove the gasket from the heating pipe and
install the new one.
Put the damper in its place and make sure that the
guiding groove is in the correct position. Tighten
the screws. The burner is now ready to be
connected to the heater.
Install the burner and tighten the screws. Before tightening, check the position of the burner to
ensure that it is in the centre of the heating pipe by confirming that the fastening nuts are symmet-
rically in the appropriate grooves.
Install the fuel hose and power cables.
Connect the power cable to the power socket and press the power switch to activate the heater.
Remember to bleed the burner to discharge any air from the system. (Bleeding instructions can be
found in the manual.)
Test run the device for at least 10 min and ensure that everything is in order. The heater is ready
for use.
14.
15.
16.
17.
18.