GAS HOB MODELS PWL 59 PXL 59 35687-8901 INSTRUCTION BOOKLET IL
Important Safety Information You MUST read these warnings carefully before installing or using the appliance. Installation z z z z z This appliance must be installed by qualified personnel, according to the manufacturer’s instructions and to the rules in force. Remove all packaging before using the appliance. Ensure that the gas and electrical supply complies with the type stated on the rating plate, located near the gas supply pipe. Do not attempt to modify the appliance in any way.
Description of the Hob 2 3 3 1 4 8 1. Hob Top 7 6 5 2. Triple Crown Burner 3. Semi-rapid Burners 4. Auxiliary Burner 5. Control knob for back right burner (semi-rapid) 6. Control knob for back left burner (semi-rapid) 7. Control knob for front left burner (triple crown) 8. Control knob for front right burner (auxiliary) Installation Any gas installation must be carried out by qualified personnel, and in accordance with existing rules and regulations.
Operation This hob is provided with a safety device, which will stop the gas flow if the flame accidentally goes off during cooking. ) To light a burner: turn the relevant control knob anticlockwise to maximum position and push it down to ignite; - upon ignition, keep the knob pushed down about 5 seconds, to allow the safety device to be switched off; - then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again.
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added.
Something Not Working? If the appliance is not working correctly, please carry out the following checks before contacting your local Service Centre. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on. Check the mains fuse has not blown. Check the burner cap and crown have been replaced correctly, e.g. after cleaning.
Installation FO 1010 IMPORTANT This appliance must be installed by qualified personnel. The manufacturer will not accept liability, should the above instructions or any of the other safety instructions incorporated in this book be ignored. Gas Connection On the end of the shaft (A) , which includes the GJ 1/2" threaded elbow, an adjustable joint is fixed so that the washer (B) is fitted between the components as shown in the diagram.
Building over a kitchen unit with oven 30 550 min. 560 min. 591 If the hob is built into a kitchen unit with an oven underneath, the recess must have the dimensions shown in diagrams 2 and 3, and should also incorporate suitable oven crosspiece supports to ensure an efficient cooling air circulation. Diagrams 4 and 5 give two building-in examples.
Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person, in accordance with the current regulations. THIS APPLIANCE MUST BE EARTHED. The manufacturer declines any liability should these safety measures not be observed. This appliance is designed to be connected to a 230 V 50 Hz AC electrical supply.
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguished follow the procedure below. Procedure: Re-ignite the burner and set to MIN. Remove the control knob, use a thin bladed screwdriver to turn the adjustment screw.
