user manual Freezer CI2590 NFA+
electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.
electrolux 3 • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or damaged power plug may overheat and cause a fire. 3.
electrolux and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. • This product must be serviced by an authorized Service Centre, and only genuine spare parts must be used.
electrolux 5 When the appliance is switched off, Display also goes off. Temperature regulation The temperature within the appliance is controlled by the Temperature regulator situated at the top of the cabinet. To operate the appliance, proceed as follows: • turn the knob clockwise to obtain the maximum coldness • turn the knob counter- clockwise to obtain the minimum coldness. The intermediate position is usually the most suitable.
electrolux plate , a label located on the inside of the appliance. The freezing process lasts 24 hours: during this period do not add other food to be frozen. Storage of frozen food When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings.
electrolux 7 • Once defrosted, food deteriorates rapidly and cannot be refrozen. • Do not exceed the storage period indicated by the food manufacturer. Care and cleaning Caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians.
electrolux Problem Possible cause Solution The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket correctly. Connect the mains plug to the mains socket correctly. The appliance has no power. There is no voltage in the mains socket. Connect a different electrical appliance to the mains socket. Contact a qualified electrician. The Pilot light flashes. The appliance is not working properly. Contact a qualified electrician. The buzzer sounds.
electrolux 9 Technical data Dimension of the recess Height 1225 mm Width 560 mm Depth 550 mm Rising Time 24 h The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Installation Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
electrolux 2 1 Ventilation requirements The airflow behind the appliance must be sufficient. min. 200 cm2 2. Adjust the appliance in the niche. The lower hinge cover (in the accessories bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Open the door. Put the lower hinge cover in position. min. 200 cm2 4mm 44mm Installing the appliance Caution! Make sure that the mains cable can move freely. Do the following steps: 1. Install the appliance in the niche.
electrolux 11 Attach the hinge covers (E) to the hinge. I D C E 4. Push the sealing strip between the appliance and the adjacent cabinet. E 7. Disconnect the parts (Ha), (Hb), (Hc) and (Hd). Ha Hb Hc Hd 5. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of right hinge, SX in opposite case. 8. Install the part (Ha) on the inner side of the kitchen furniture. ca. 50 mm 90° 21 mm 90° ca. 50 mm 6.
electrolux 8 mm Ha K Hc Ha 10. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. 12. Place the small square on the guide again and fix it with the screws supplied. Align the kitchen furniture door and the appliance door by adjusting the part Hb. 8 mm Ha Hb Hb 13. Press the part (Hd) on the part (Hb). 11.
electrolux 13 • The magnetic sealing strip is attached tightly to the cabinet. Environmental concerns The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment.
electrolux
electrolux 15
www.electrolux.
