Assembling Monarco HAT and Raspberry Pi Monarco HAT – Lightweight I/O for the Raspberry Pi minicomputer https://www.monarco.io © REX Controls s.r.o.
Step 1 – Raspberry Pi Use metal spacers to attach the Raspberry Pi to the bottom part of the aluminium case.
Step 2 – Monarco HAT Attach the Monarco HAT on top of the Raspberry Pi and use screws to fasten it.
Step 3 – Side panels Mount the side panels and tighten the screws.
Step 4 – Closing the case Mount the cover and tighten the screws.
Step 5 – Connector and micro SD card Plug in the connector and micro SD card. Make sure that the locking levers are in the middle position.
Step 6 – Mounting DIN rail holder Insert the holder according to your preferences. This is for the first choice of vertical mounting...
… this is the second choice of vertical mounting...
…and this is for horizontal mounting.
Step 7 - DIN rail mounting The aluminium case allows vertical mounting...
... as well as horizontal mounting.
Congratulations, your miniature industrial PC (or PLC if you prefer) is ready for use!
