User Manual

Revv Owner’s Manual - 20
Balanced Out - XLR
The balanced out XLR connector on the rear of the amplifier is a direct
output from the embedded Two notes Torpedo and not direct from the
tube amplifier output itself. The purpose of this output is to be used with
audio interfaces to exclude the use of an actual speaker cabinet, using
virtual cabinets instead.
Note: The reverb or other effects that the Two notes Torpedo provides
will only be available through the output at the headphone or XLR jack
and not a real cabinet. The speaker output will always behave normally.
As an added bonus, some users will find this useful for “wet/dry” setups in
which they send a signal that utilizes reverb to front of house, while playing
through a dry cabinet.
In order to run the output of the D20 to an audio interface, connect the
D20 to the audio interface with an XLR cable. Set the amplifier up the way
you intend to play, (EQ, volume) and then adjust the output of the bal-
anced out with the small trimmer on the front of the amplifier. You will want
to turn the level up until the clip LED illuminates and then back it off, or
adjust it to the parameters of the audio interface.
The Ground Lift switch should be set to ground (pushed in) for best
results. However, if this produces a buzz or hum because of ground loops
between the D20 and the audio interface, press the ground lift switch to
eliminate noise.
6.0