Technical data

Multi Media
Re:source
43
Synchronising MyMusic
The following display appears the first
time the MMM is started on the remote
control:
The MyMusic selection has not yet been
synchronised in this constellation.
Connect the M208 with the supplied USB
cable to the M208 Link inter-face for
synchronisation. The Link interface for its
part is connected to the M10 / M51
through a cable to the M Link.
Once the connection is established,
select the source key at the M208 where
the MMM controller is stored and press
the
SETUP key. Confirm the setting
Synchronize with the OK key.
Important advice
The M208 remote control must not be
operated while synchronisation is
running.
Synchronisation now starts and only
takes a few seconds. When the
synchronisation is complete, the
following display appears:
Now, all stored
MyMusic entries appear
in the display the next time the MMM
controller is called. The display order is
determined by the order they were
stored in the MMM.

A synchronisation with the M208 should
always be carried out if you modify any
of the
MyMusic entries in the MMM by
adding new ones or deleting existing
ones. Otherwise, wrong
MyMusic
entries will be called.