Technical data

Communication SAT Re:source
4
Installation
The Communication plug-in
card is equipped with the latest
in electronics and should be
handled with care.
Before you install the card, the
M51/ M10 must be switched off
and separated from the power
supply, by plugging the unit out.
M51 Installation
The Communication module
can be operated in slots 1 – 6.
The only exception is Slot 7,
next to the speaker connections,
as this is reserved for the 5.1
Decoder module.
M10 Installation
The Communication module
can be operated in slots 1 – 8.
Slots A1 and A2 may only be
populated with second
generation modules whose
hardware has been developed
since 2008. These can be
identified by the following
symbol on the back wall of the
module:
Loosen the two screws with a
TORX screwdriver (T10) and
remove the blanking plate. A
suitable TORX screwdriver is
supplied with the Re:system
M51 and M10.
Before removing the
Communication module from its
packaging, you should make sure
that you do not have any static
electricity. This could cause a
damaging discharge of voltage
when you touch the module. You
should get rid of any static charge
by touching an earthed metal
object like a radiator, for example.
Remove the Communication
module from its packaging and
feed it into its plug-in position.
The two bars inside the M51/
M10 are the mechanical guides
for you to use.
The lettering on the
Communication plug-in card
must be on top. Shortly before
the plug-in card is fully locked
into position in its slot, you will
feel a mechanical resistance,
caused by the contact strip.
Push the Communication
module in by applying pressure
in the area of the two screw
holes and fix the card in place
with both screws.
All further steps for the internal
registering of the new module
are carried out automatically the
next time it is switched on.
G²