Technical data

Communication SAT Re:source
13
Default reproduction
With the Topfield receiver, you
can receive radio programs as
well as TV programs. Using the
Default function, you can now
choose between 3 options as to
which (SAT) source – TV or radio
– will be taken to start with, when
you choose SAT from the Source
menu.
Default: Off
The source will be selected,
which was being used before
power-off or before switching
sources.
Default: Radio
Irrespective of which (SAT)
source you last selected, Radio
will always be selected as the
source when you select SAT.
Default: TV
Irrespective of which (SAT)
source you last selected, TV will
always be selected as the source
when you select SAT.
You change the setting by
repeatedly pressing the Default
softkey.
Configuring the digital input
When installing the SAT module
in an M51, you have the option to
use the digital audio signal from
the Topfield receiver in the main
room. In this case, the Topfield
receiver digital output is
connected to the digital input on
the 5.1 decoder module.
Digital input: Optical (at the 5.1-Decoder)
This has the advantage that
digital multi-channel formats such
as Dolby or DTS, significantly
improve the reproduction quality
with the Home cinema. A pre-
requirement of course is that the
television channel also transmits
the programmes in the mufti-
channel format. Otherwise, only
stereo reproduction is available.
The additional rooms continue to
be supplied with the analogue
audio signal through the IN4
input.
If the SAT module is installed in
an M10, the configuration of the
digital input is blocked, as the
M10 doesn't have a 5.1 decoder
module.