Technical data

Communication SAT Re:source

SAT input IN 4 + RS232

Two connections have to be made between the Topfield receiver and the

Communicate module.

1.) Audio connection input IN 4 (Communicate module) with the

audio output L-R (Receiver) using a stereo cinch cable.

2.) RS232 control connection with a serial 1:1 cable (plug – socket).

Cabling has to be done as shown in the diagram below. Depending on

the receiver type, the connections can be in different positions on the

back of the device.

The cable length between the Communicate module and the receiver

should not be more than 10 metres as otherwise you can expect to

experience disturbances and reduced audio quality.

All other connections between the receiver and the SAT system and/or

the image producing device are made according to individual needs and

system features.

You will find the corresponding documentation in the Receiver Operating

manual from Topfield.

L The receiver must be switched on permanently so

that the Communicate module can access it all times.

CAUTION

RISK OF ELECTRICAL SHOCK

DO NO T OP EN

AC INPUT 90-250V ~

50-60 Hz Power

Consump tion : 55 W

RS- 2 3 2

S/ PD I F

RF I N

RF O UT

USB

VC R

S-V H S

VID EO

AUDIO

LNB 1 IN

LNB 1 OU T

LNB 2 IN

LNB 2 OU T

RF O UT

Aud io L-R

RS2 3 2

L IN R

Comm.

RS 232