Technical data

Kaleidescape
Re:source
5
Connection panel
RS232 connection
The RS232 communication
interface is connected to the
Kaleidescape Music Player
through a 9-pin Sub-D cable (1:1
connection; plug-socket). The
Music Player interface must be
adjusted to ensure correct
communication.
The Music Player Setup menus
are operated through a Web
Browser. You will find information
about this in the next chapter
Music Player Setup.
Music Player RS232 settings
Baud rate: 57600 bit/s
Data bits: 8 bits
Parity: None
Stop bits: 1
Flow control: None
Audio connections
The Kaleidescape module has 4
independent audio inputs that are
connected with the 4 audio outputs
on the Music Player.
IN 1 for Out-1
IN 2 for Out-2
IN 3 for Out-3
IN 4 for Out-4
These audio connections are
intended exclusively for
transmissions from the Music
Player to the Main room and the
Additional rooms.
Independent of that, each Movie
Player still has to be connected
with the corresponding audio
amplifier, e.g. M51 MR unit,
M219, M51 Slave. You will find
more information in the Chapter
Movie Player Cabling, Page 12.
Use a Stereo Cinch cable for
each of the connections between
Kaleidescape module and Music
Player. These cables may have a
maximum length of 10 m.
L IN R
Comm.
RE V
OX
1
2
3
4
RS 232