Technical data

Kaleidescape
Re:source
4
Installation
The Communication plug-in card
is equipped with the latest in
electronics and should be
handled with care.
Before you install the card, the
M51 must be switched off and
separated from the power supply,
by plugging the unit out.
The Communication module can
be operated in each slot. The only
exception is Slot 7, next to the
speaker connections, as this is
reserved for the 5.1 Decoder
module.
Loosen the two screws with the
TORX screwdriver supplied and
remove the blanking plate.
Before removing the
Communication module from its
packaging, you should make sure
that you do not have any static
electricity. This could cause a
damaging discharge of voltage
when you touch the module. You
should get rid of any static charge
by touching an earthed metal
object like a radiator, for example.
Remove the Communication
module from its packaging and
feed it into its plug-in position.
The two bars inside the M51 are
the mechanical guides for you to
use.
The lettering on the
Communication module must be
on top. Shortly before the module
is fully locked into position in its
slot, you will feel a mechanical
resistance, caused by the M51
contact strip. Push the
Communication module in by
applying pressure in the area of
the two screw holes and fix the
card in place with both screws.
All further steps for the internal
registering of the new module are
carried out automatically by the
M51 the next time it is switched
on.