Technical data

Multiroom Module 03
Re:source
3
Installation
The Multiroom plug-in card is
equipped with the latest in electronics
and should be handled with care.
Before you install the card, the M51/
M10 must be switched off and
separated from the power supply, by
plugging the unit out.
M51 Installation
Slot 5 is reserved for the Multiroom
module, the fifth slot from the right
viewed from the back of the unit.
M10 Installation
Slot 5 is reserved for the Multiroom
module, the fifth slot from the right
viewed from the back of the unit.
Slots A1 and A2 may only be populated
with second generation modules
whose hardware has been developed
since 2008. These can be identified by
the following symbol on the back wall
of the module:
Loosen the two screws with a TORX
screwdriver (T10) and remove the
blanking plate. A suitable TORX
screwdriver is supplied with the
Re:system M51 and M10.
Before removing the Multiroom module
from its packaging, you should make
sure that you do not have any static
electricity. This could cause a damaging
discharge of voltage when you touch the
module. You should get rid of any static
charge by touching an earthed metal
object like a radiator, for example.
Remove the Multiroom module from its
packaging and feed it into its plug-in
position. The two bars inside the M51/
M10 are the mechanical guides for you
to use.
The lettering on the Multiroom plug-in
card must be on top. Shortly before the
plug-in card is fully locked into
position in its slot, you will feel a
mechanical resistance, caused by the
contact strip. Push the Multiroom
module in by applying pressure in the
area of the two screw holes and fix the
card in place with both screws.
All further steps for the internal
registering of the new module are
carried out automatically the next time
it is switched on.