Technical data

Multiroom Module 03
Re:source
29
IR Output configuration
The IR Link is configured through the
Option menu. You get to this in the
Setup / Multiroom menu. You get to the
second page by pressing the
Menu
softkey, where you will find the menu
point
Option.
Select the IR output
Select IR Output 1 or 2 and set up the
corresponding third-party device that
you want to control through the
Code
softkeys.
In our example, this is an Argon DAB+
Adapter V3. Make sure that the IR
Sender on the IR Transmitter is directly
above the IR Eye on the third-party
device, in this case the DAB Tuner.
Now in the second step, using the Input
softkey, you select the source through
which the third-party device is
connected audio-technically with the
M51/M10. Here, we recommend using
Aux1 (M218 Keypad: Server) or Aux2 as
these sources can be directly called at
the press of a key, through the wall-
mounted unit in the side room.
With the selection Input, you release
the throughput for the IR signal,
dependant on the audio source.
This means, that if the audio source
(Input)
Aux2 is selected, the IR Link
signal can only pass through the
Multiroom module, if the
Aux2 source
is also active in the side room. If
another source is active or if the side
room is switched off, the IR Link
command is blocked.
Important advice
The same signal is always available at
the two outputs
IR Send 1 and 2 on the
Multiroom module. Both codes will be
sent however, depending on the
selected configuration.
For this reason, it is not possible to
control two identical devices, e.g. 2 x
Argon DAB+ Tuners, because as well
as Device 1, Device 2 would also react
to the commands and vice-versa.