Technical data

Multiroom Module 03
Re:source
18
Special Events
Using the Timer programming, you can
also generate nested Events. By a
nested timer, we mean the situation
where two different timer address the
same source and the same room at the
same time.
In our example, Timer 1 and Timer 2
overlap. Since they both address the
same source and the same room,
Timer 1 defines the Switch on
timepoint (first On trigger) while
Timer
2 defines the switch off timepoint (first
Off trigger).
.

With a nested timer, the timer which
starts and respectively ends earlier
defines the on and off timepoints.
Sleep function
Using the Sleep function, you can set a
particular length of time, after which
the M51
will automatically switch off.
By pressing the Sleep key repeatedly,
you can set the required time interval
in 15 minute steps. The continuous
loop starts with 90 minutes and ends
with the switching off of the
Sleep
function.
The currently Sleep time is shown in
the bottom line of the display, on the
right-hand side.
Timer 2
Timer 1
ON
ON
OFF
Switched time
OFF
90‘
75‘
60‘
45‘
30‘
15‘
OFF s