Technical data

Multiroom Module 03
Re:source
17
Test function
The Test function allows you to carry
out an effective check of the Timer
settings. In particular with room
selection and volume, you can check
whether the right room is activated
and that the right volume level has
been set.
Once you have entered all the Timer
settings, press the
Test softkey.
Immediately, the selected
room/additional room is activated.
Now you can go to the room in
question and check, for example,
whether the volume for your morning
radio wake-up call is set to an
acceptable level. If necessary, you
can adjust it and then carry out the
test again.
Using the Off command on your
remote control of the wall-mounted
controller, you can switch the
additional room off again. All
additional rooms can also be switched
off together by pressing and holding
the Power button for a few seconds
Activating the timer
As standard, the individual timers are
deactivated.
Each Timer can be activated or
deactivated separately.
To activate or deactivate an Timer,
select the required timer and then
using the
On/Off softkey, activate it or
deactivate it accordingly. The state of
the Timer is shown as below:
Additionally, when you leave the
activated timer a bell symbol right
down in the display of the M51 is
shown. This
indicates that at
least one of the four
main room timers is
activated.
Important
Active timers that affect the additional
rooms are
not displayed with the bell
symbol