Technical data

Multiroom Module 03
Re:source
10
Timer programming
The concept behind timer
programming is as follows:
Firstly you select the room that should
be controlled by the timer. Then you
assign the corresponding properties to
one of the four possible timers.
With the maximum number of 32
additional rooms plus the main room,
up to 132 timers are available.
The following graphic shows the inner
Timer display field with the
corresponding assignments.
Room selection
As the first step, you select the room
that is to be controlled by the four
possible timers.
You select the required room with the -
Room + softkeys.
Only those rooms that are actually
connected to the M51 are shown.
The selectable rooms are shown in an
endless loop, as shown below:
Weekday
Timer
Switching time
Room
Source
Volume
Main Room
Room 1.1
Room 1.2
:
:
Room 4.7
Room 4.8