Owner`s manual

r'., T i":i 1_:: i T i:::'"i_
L.' .;.r"i L..'..a :: L.. a.i
r'., T iDi:::' F""i _
L.' .LF',L..'...'
7,:::.i_:!!!;t..,i?i."eo
,.... i L..L.."FL.A
....q.... L.. L..'vU..A
':::;_;i'i i:::'i.Ji::q
qF: i i:::'i.Ji::q
L.. L.. L..'vU..A ....
i:::,C, i i:::'i ii:::'i
F.. I....L..'vU...l
Dialog lilt. Adjusts the height ol the h'ont and center channel sounds by assigning some ol the
lront and center channel elelnents to the presence speakers. The larger the parautcter, the higher
the position ol the lront and center channel sound.
Choices: 0, 1,2, 3, 4, 5
2-channel stere() direct. Bypasses tile decoders and DSP processors of this unit Ik)r pure hiq:i stere()
sound when playing 2-channel analog sources.
( hoices: AUTO, OtF
• Select "AUTO" Io bypass the decoders, DSP processors and the tone conFol circuitry only
when "BASS" and "TREBLE" are set to 0 dB/see page 50).
• Select "OFF" not to bypass the decoders, DSP processors and the tone control cilvuilry when
"BASS" and "TREBLE" are set to 0 dB.
• When multi-channel signals (Dolby Digital and DTS) arc input, they are downmixed to 2
channels and output from the lhont left and right speakers.
• The low-fl'equency signals input fl'om the front left and right speakers are redirected to the
subwoofcr in the lollowing cases:
-"LFEIBASS OUT" is set to "BOTH" (see page 87).
"FRONT SP" is set to "SMALL" (see page 88) and "LFE/BASS OUT" is set to "SWFR"
(see page 87).
7-channel stere() center, sumxmd left, surround right, surf(rand back, presence left and presence right
Iexels. Adjusts tile xolume Iexel of each channel in tile 7-channel stereo mode.
Control range: 0 to I0()_-
• Selecting decoders for 2-channel
sources (surround decode mode)
Use this feature to play back sources with selected
decoders. You can play back 2-channel sources on nmlti-
channels.
1 Set the operation mode selector to AMP and
then press SUR. DECODE on the remote
control to select the surround decode mode.
SURBECOBE
TV
Press SELECT on the remote control
repeatedly to select the desired decoder.
You can select from the following modes depending
on the type of source you are playing and your
personal preference.
SELECT
%
• You carl select the desired decoder by pressing SELECT
and then press <1 / C> repeatedly on the remote control.
• You can change the decoder parameter settings. Press
PARAMETER and then _ / V repeatedly on the remote
control to select the desired decoder parameter. You can
change the value of the selected parameter by pressing
<1 / t> repeatedly on the remote controh
80 En