Owner`s manual

Recording adjustments and other operations are performed fl'om the recording components. Refer to tbe operating
instructions for those components.
The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in
noise being recorded. Therefore, if you want to use this unit to record sources encoded in DTS, the
following considerations and adjustments need to be made. To play DTS-encoded DVDs and CDs
(when using a digital audio connection) on your DTS-compatible player, follow its operating
instructions to make a setting so that the analog signal will be output from the player.
• When this unit is set to the standby mode, you cannot record between other components connected to this unit.
• The settings ol TONE CONTROL (see page 50), VOLUME, the speaker lexel (see page 90) and the sound lield programs (see
page 45) do not allect recorded materiah
• The source connected to the MULTI CH INPUT jacks ol this unit cannot be recorded.
• The XM Sittellite Radio signals (U.S.A. and Canada models only) cannot be output at the AUDIO OUT (V.EC)jacks.
• Digital signals input at the DIGITAL INPUT jacks are not output at the analog AUDIO OUT (I".EC) jacks lot recording. Likewise,
analog signals input at the AUDIO 1Njacks are not output at the DIGITAL OUTPUT jack. Therelore, il your source component is
connected to proxide only digital or analog signals, you can only record digital or analog signals.
• A given input source is not output on the sltme OUT (REC) channeh
• S-x ideo and composite xideo signals pass independently through the _,ideo circuits ol this I.lniLTherelore, when recording or dubbing
_ideo signals input lrom a video source component that provides only an S-_ideo or a composite xideo signal, you can record only an
S-video or a composite xideo signal on your VCR.
_v
• The analog audio signals input at the DOCK terminal can be output at the analo_ AUDIO OU 1 (REC) jacks for recording.
• Check the copyright laws in your country to record h'om CDs, radio, etc. Recording ol copyrighted lnaterial inay inlringe copyright
laws.
_.,&
Do a test recording belore you start an actual recording.
If you play back a video source that uses scrambled or encoded signals to prevent it fl'om being dubbed, tbe picture
itself may be disturbed due to tbose signals.
(U.S.A. model)
Rotate the INPUT selector on the front panel
(or press one of the input selector buttons on
the remote control) to select the source
component you want to record from.
INPUT
000%
Front panel Remote control
(U.S.A. model)
Turn on all the connected components.
3 Start playback on the selected source
component or select a broadcast station.
4 Start recording on the recording component.
75 En