Owner`s manual

IRliV.1_:_Df,
YOUcan display the format, sampling frequency, channel,
bit rate and flag data of tbe current input signal.
• Audio information
Signal format li:::''" C, i')_,", "f '_,..'_'..1 Ir"l I
Signal format. When this unit cannot detect a digital
signal, it atttomatically switcbes to analog input.
1 Set the operation mode selector to AMP and
then press SET MENU on the remote control.
Tbe top "SET MENU" display appears in the OSD.
E,E.i i']gi'gJ
÷ ,gLIT0 SETLIp
, HI:IHLlgl_SETUP
, SiGIqgL If,IF0
[ ENTER _ :En<:er
Press V repeatedly to select "SIGNAL INFO"
and then press ENTER.
Tbe audio information about the input source appears
in the OSD.
PRESET_H PRESET/_H
*X *X
Press A / V repeatedly to navigate the cursor
in the OSD and press <S/ [:> to toggle
between the audio and video information
displays.
_aESEr<_H
@
Navigatingthe cursor
pRESE_H
Selecting the audio or
video information
4 Press SET MENU on the remote control again
to exit from "SET MENU".
set _E_
"---" appears when this unit cannot detect any signals.
Sampling frequency SI::iMF'L.i }.i(!)
The number of samples per second taken from a
continuous signal to make a discrete signal.
"---" appears when this unit cannot detect the sampling
lrequency.
Channel i=.i.J,...ii..ii..ii::?i
u.q _r"l H i ".q,..%,
Tbe number of source channels in the input signal
(fl'ont/surround/LFE). For example, a multi-channel
soundtrack with 3 front channels, 2 surround
channels and LFE, is displayed as "31210.1".
"---" appears when there is no source channel axailable.
Bit rate _:::,T"i=i:::,("l"i"i:::"
The number of bits passing a given point per second.
"---" appears when this unit cannot detect the bit rate.
Dialogue normalization level [:,]IAL..C,3
The dialogue normalization level preset to the current
input Dolby Digital and DTS signal.
Flag i:::i..J:::I(!!i
Hag dataencodedinDTS, DolbyDigital,orPCM
signals that cue this unit to automatically switch
decoders.
• Video information
HDMI Signal Type H[:,M]I S]i(!!iiqI::ii....
Type of"the HDMI signals input or output at the
HDMI IN/OUT.jacks of this unit.
HDMI Resolution IiI:::,M:[RES,,
Resolution of the HDMI signals input or output at the
HDMI IN/OUT.jacks of this unit.
Analog Resolution AMI::ii.C,3RES..
Resohttion of the analog signals input or output at the
video jacks of this unit.
HDMI Error HE:,M]: ERRs?F;?.
Error message for HDMI sources or connected
HDMI devices. See page 127 for details.
42 En