Owner`s manual

Use this feature to select the component connected to the

MULTI CH INPUT jacks (see page 26) as the input

SOLlrce.

Rotate the input selector on the front panel to

select MULTI CH INPUT (or MULTI CH IN on the

remote control).

MULTIC_I_

Front panel Remote control

Use "MUUI'I CH SET" menu in "INPUT MENU" to set the

parameters lor MULTI CH INPUT/see page 96).

Sound field programs and the Compressed Music Enhancer mode

cannot be selected \_hen the component connected to the MUUFI

CH INPUT jacks is selected as the input source and Audio input

jack select is set to "ANALOG" (see page 40).

ilw.l_:_Pli

Connect a pair of headphones with a stereo

analog audio cable plug to the PHONES jack on

the front panel.

When you select a sound lield program, SILENT CINEMA mode

activates automatically (see page 49)

• When you connect headphones, no signals are output at the

speaker terminals.

• When the component connected to the MUUFI CH INPUT

jacks of this refit is selected as the input source and Audio input

jack select is set to "ANALOG" (see page 40), only the signals

input at FRONT jacks are output fi'om the connected

headphones.

• All Dolby Digital and DTS audio signals are mixed down to the

left and right headphone channels.

Press MUTE on the remote control to mute the

audio output. Press MUTE again to resume the

audio output.

• You can also rotate VOLUME on the front panel or press

VOLUME +1 on the remote control to resume the audio

output.

• You can adjust the muting level by using the "MUTE TYPE"

parameter in "SOUND MENU" (see page 93).

• The MUTE indicator flashes in the fi'ont panel display when the

audio output is muted and disappears from the li-ont panel

display when the audio output is resumed.

41 En