Owner`s manual

Both FM and AM indoor antennas are supplied with this
unit. Connect each antenna correctly to the designated
terminals, in general, these antennas should provide
sufficient signal strength.
• Be sure to set the tm_er frequency step (Asia and General
models only) according to the frequency spacing in your area
(see page 119).
• The AM loop antenna should be phtced away from this refit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this refit.
• A properly installed omdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
YAMAHA dealer or service center about outdoor antennas.
Indoor FM _ c_=
antenna H J_
(supplied)_ _
%
:: _;_>S)" N;;;;s# l
(U.S.A. model)
AM loop
antenna
(supplied)
Outdoor AM antenna
Use a 5 to 1(t m (16.4 to 32.8
_1 vinyl-covered wire
extended outdoors fiom a
window.
Ground (GND terminal)
For maximum sa_bty and minimum intcrfbrcnce, connect the
antenna GND terminal to a good earth ground. A good earth
ground is a metal stake driven into moist earth.
• Connecting the AM loop antenna
1 Set up the AM loop antenna.
Press and hold the tab of the AM ANT
terminal.
Insert one of the AM loop antenna lead wires
into the AM ANT terminal.
Release the tab of the AM ANT terminal.
Repeat steps 2 through 4 to connect the
other lead wire to the GND terminal.
Once you have properly connected the AM loop antenna to
this refit, orient the AM loop antenna for the best reception
when you tune into AM stations {see page 54).
28 En