Owner`s manual

• Remote control
The remote control Wrong distance or angle. The re_;_otecontrol wilt fimction within a maximm;_
does not work or range o_ 6 m (20 l)) and no more than 30 degrees off2 9
function properly, axis from the Iront panel.
Direct sunlight or lighting (trom an Reposition this trait.
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor ot this
[mit.
The batteries are weak. Replace all batteries. 9
The operatkm mode selector is set Set the operation mode selector correctly.
incorrectly. When operating this unit, set it to the AMP position.
When operating the component selected by the input
selector button, set it to the SOURCE position.
When operating the TV set in the DTV or PItONO
area. set it to the TV position.
Set the remote control code correctly using
"LIST OF REMOTE CONTROL CODES" at the end 103
ot this manual.
The ret;lote control code was not correctly
set.
Try,setting another code of the same manufacturer
using "LIST OF REMOTE ( ONTROL (ODES" at
the end ot this _;_mnual.
103
The library code of the remote control and Match the remote control tD of this unit with the
the ret;lote control IDol this unit do not corresponding remote control library, code. 104, 11g
match.
E*,enit'the remote control code is Prografn the necessary f[mctions independently into
correctly set, there are some models that the programmable buttons using the Learn feature. 105
do not respond to the remote controI.
The remote control The batteries ol this remote control and/or Replace the batteries. 9
does not learn new the other remote control are too weak.
functions.
The distance hetween the t_,,ore_;_ote I lace the remote controls at the proper distance. 105
controls is too _;l[tchor too little.
The signal coding or modulatkm of the Learning is not possible.
other remote control is not compatible
with this remote control.
Memory capacity is full. Delete other unnecessary functions to make room lor
110
the ne_\ functions.
• HDMI
r",iill'i i T {"'ill:" {"it iiII:'iD The number ()_ tile connected }lI-)l_'l[ Reduce tile number ()1 tile connected [II-)N_][
components is o_,erthe limit, co_;_ponents.
i...ir'.,¢=q:::,i:::'i::M:::,i"H::) tlf)CI authentication Iailed. Check that the connected IIDMI components support
the |IDCP copy protection standards.
127 En