Owner`s manual

No sound is heard sun. L/R SP" in SET MENU" is set to Set sun. L/R SP" and _SB L/R SP" to a setting 88
from the surround NONE" and SB L/R SP" is other than NONE".
back speakers, automatically set to "NONE".
"SB L/R SP" in _SET MENU" is set to Set "SB L/R SP" to a setting other than "NONE". 89
NONE".
Dolby Digital or DTS The connected component is not set to Make an appropriate setting Ibllowing the operating --
sources cannot be omput Dolby Digital or DTS digital instructions for y(mr component.
played. (Dolby Digital signals.
or DTS indicator in
the front panel Audio input jack select is set to Set Audio input jack select to AUTO". 40
display does not light "ANALOG".
up.)
A humming sound is Incorrect cable connections. Connect the audio cables firmly. It the problem
heard, persists, the cables may be deiective.
No connection iixm_ the turntable to the Connect the grounding cable ol your turntable to the 24
GND terminal. GND terminal oJ this unit.
The volume level is The record is being played on a turntable Connect your turntable to this unit through an MC- 24
low while a record is with an MC cartridge, head amplifier.
being played.
The volume level The component connected to the AUDIO Tm'n on the po_\ er ol the component.
cannot be increased, OUT (REC) i:tcks o1 this tlnit is ttlrned
or the sound is off
distorted.
The sound effect It is not possible to ik?cord the sound effect
cannot be recorded, with a recording component.
A source cannot be The source component is not connected to Connect the source component to the DIGITAL 22, 24
recorded by a digital the DIGITAL INPUT jacks of this unit. INPUT jacks.
recording component
connected to the Some components cannot record Dolby
DIGITAL OUTPUT Digital or DTS so_lrces.
jack.
A source cannot be The sonrce component is not connected to Connect the s(mrce component to the analog AUDIO 24
recorded by an the analog AUDIO IN ,jacks of this unit. IN jacks.
analog component
connected to the
AUDIO OUT (REC)
jacks.
The sound field MEMORY GUARD" in "SET MENU" Set MEMORY GUARD' to OFF'. 98
parameters and some is set to '()N".
other settings of this
unit cannot be
changed.
124 En