Owner`s manual

No picture
Short message
displays do not
appears in the video
monitor
The sound suddenly
goes off.
The output and input lbr the picture are
connected to diffi.,rent types ol video
jacks.
Non-standard video signals are input.
Only the center
speaker outputs
substantial sound.
Set W C()NV." to ON" or connect your source
coiT/lponents ii/the same way as yon connect your
video monitor to this unit.
97
SttORT MESSAGE" is set to OFF". Set SttORT MESSAGE" to "ON".
98
GRAY BA( K" is set to "OFF". Set"GRAY BACK"to"AUTO".
97
W CONV." is set to _OtT".
Set W CONV." to "ON". 97
The signals input at the ItDMI INI or
tlDM1 IN2 jack ate being output at the
ItDMI OUT jack.
Video signals in the progressive lormat or
ttDTV video signals are being input.
The protection circuitry has been activated
because of a short circuit, etc.
Check that the speaker impedance setting is correct. 30, 118
Check that the speaker wires are not touching each
other and then turn this unit back on.
The sleep timer has turned oil this unit. Turn on this unit, and play the source again.
The sound is muted. Press MUTE or VOLUME on the remote control 41
to resume audio output.
Sound is heard from Incorrect cable connections. Connect the cables properly. 11 the problem persists, 14
the speaker on one the cables may be delective.
side only.
Incorrect settings in _'SP LEVEL". Adjust the SP LEVEL" settings. 90
When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front and surround speakers output eflect
SOLtnds.
No sound is heard "CENTER SP" in SET MENU" is set to Set "CENTER SP" to SML" or"LRG". 88
from the center NONE".
speaker.
One ol the t liFi DSP programs (except lor Try :mother sonnd field program. 45
"7ch Stereo") has been selected.
No sound from the The sound f_eld programs are turned off. Press STRAIGHT to turn them on. 49
presence speakers
You arc using a source or program Try :mother sound field program. 38
combination that does not output sound
from all channels.
No sound is heard _SUR. L/R SP" in _SET MENU" is set to Set _SUR. L/R SP" to _SML" or LRG". 88
from the surround NONE".
speakers.
This unit is in the _STRAIG| iT" mode Press STRAIGtIT on the lront panel so that 49
and a monaural souive is being played _STRAIGttT" disappears from the lront panel
back. display.
No sound is heard LFE/BASS OUT" in SET MENU" is Set LFE/BASS OUT" to SWFR" or' BOTII". 87
from the subwoofer, set to "FRONT" when a Dolby Digital or
DTS signal is being played.
"LFE/BASS OUT" in %ET MENU" is Set "LFE/BASS OUT" to _BOTIt". 87
set to SWFR" or _FRONT" when a 2-
channel source is being played.
The source does not contain Iow-
frequency signals.
123 En