Owner`s manual

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
YAMAHA dealer or service center.
• General
This unit fails to turn The power cable is not connected or the Connect the power cable firmly.
on or enters the plug is not completely inserted.
standby mode soon
after the power is The speaker impedance setting is Set the speaker impedance to match }our speakers. 30
turned on. incorrect.
The protection circuitry has been Make sure that atl speaker wire connections on this 14
activated, unit and on atl speakers are secure and that the wire
for each connection does not touch anything other
than its respective connection.
This unit has beer] exposed to a strong Set this unit to the standby mode, disconnect the --
extemat electric shock (such as lightning power cable, plug it back in alter 30 seconds and then
or strong static electricity), use it normally.
No sound Incorrect input or output cable Connect the cables properly. II the problem persists, 21-27
connections, the cables may be delective.
The optimizer microphone is connected. Disconnect the optimizer microphone. 36
Audio input jack select is set to "ttDM[", Set Audio input jack select to "AUTO". 40
COAX/OIrF '' or 'ANALOG".
Audio input jack select is set to Set Audio input jack select to 'AUTO" or 40
_ANALOG" while playing a source _COAX/OIrF ''.
encoded in Dolby Digital or DTS.
No appropriate input source has beer] Select an appropriate input source with the INPUT 38, 41
selected, selector on the front panet (or the input selector
buttons on the tk?mote control).
Speaker connections are not secure. Secure the connections. 14
The volume is turned down. Turn up the volume.
The sound is muted. Press MUTE or VOLUME +/ on the remote control 41
to resume :radio output and then adjust the volume.
Signals this unit cannot reproduce are Play a source whose signals can be reproduced by this
being input irom a source component, unit.
such as a CD-ROM.
The tlDM[ components connected to this ( onnect tlDMI components that support the HDCP 19
unit do not support the ttD(P copy copy protection standards.
protection standards.
"SUPPORT AUDIO" is set to OTtlER" Set "SUPPORT AUDIO" to _RX-V I700" in 93
and "HDM[" audio signals are not being "MANUAL SETUP".
played back on this unit.
122 En