Owner`s manual

4 Press the numeric buttons to enter the
four-digit remote control code for the input
area you want to use.
CLASSICAL UVFJCLUB ENTERTAIN MOVIE
Remote control AMP codes
Select one of the following codes to set the remote conm)l
AMP code for the input area you want to use.
1
Setting remote control tuner ID or XM ID
Set the operation mode selector to AMP or
SOURCE and then press TUNER or XM on
the remote control to select the tuner or XM
to change the remote control ID.
{_) TUNER
TV
©
or _ or
SOUmE
200t To operate this trait using the IDI
(initial setting) delimh code. (initial setting)
2002 To operate this unit using an ID2
ahernati_, e code.
Note
Youneed to set the corresponding remote comrol AMP ID
(see page 1 18).
5 Press ENTER to set the number.
"OK" appears in the display window if"setting was
successful.
"NG" appears in the display window if the setting
was unsuccessful. In this case, start over fl'om step 1.
6 Press LEARN again to exit from the setup
mode.
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
then press <1/ _> repeatedly until "L;TUN"
and "TUNER", or "L;TUN" and "XM"
alternately appear in the display window on
the remote control.
PRES_'CH
• Be sure to press and hold LEARNfor atleast 3 seconds,
otherwise the learning process will start.
• If you donot complete each of the following steps within
30 seconds, the setting modewill be automatically
canceled. In this case, start over from step 1.
Press ENTER.
The four-digit code set for the selected input area
appears in the display window on the remote control.
120 En