Owner`s manual

• Tuner frequency step "{"Ui"4E{;?,{:::'{:;?JT!!!!/i'EF:'
(Asia and General models only)
Use this feature to set tile tuner frequency step according
to the frequency spacing in your area.
Choices: AM10/FM100, AM9/FM50
• Select "AM10/FM100" for North, Central and South
America.
• Select"AM9/FM50" for all other areas.
Use to activate or deactivate the bi-AMP flmction.
Choices: ON, OFF
• Select "ON" if you want to activate the hi-AMP
function.
• Select "OFF if you want to deactivate the hi-AMP
function.
When BI-AMP is set to ON, the SURROUND BACK terminals
cannot be used to connect sm'round back speakers in that the
SURROUND BACK terminals arc already used lk_rthe bi-AMP
connection (see page 17).
• Video reset _irrs_:::,-,_:::,i:::,::_:::"r
Use to initialize the parameter settings for "DISPLAY
SET" in "OPTION MENU" (see page 97).
Choices: YES, CANCEl_
Note:
The parameter setting lor "DIMMER', "SHORT MESSAGE",
"ON SCREEN" and "EL SCROLL" is not initialized (see
page 97).
ilol71h'l_lqoi=l--ii q
When using multiple YAMAHA receivers/amplifiers, you
may be able to operate the other components
simultaneously with the default code setting. In this case,
set one of the alternative codes to operate this unit
separately.
• Setting remote control AMP ID
1 Set the operation mode selector to AMP or
SOURCE.
Press and hold LEARN for about 3 seconds
using a ballpoint pen or similar object and
then press <1/C> repeatedly until "L;AMP"
appears in the display window on the remote
control.
PRESEI_H
,_ E/I;AI'[ ',
• Be sure to press and hold LEARN for at least 3 seconds,
otherwise the learning process will start.
• If you do not complete each of the following steps within
30 seconds, the setting mode will be amomatically
canceled. In this case, start over from step 1.
3 Press ENTER.
The four-digit code set for the selected input area
appears in the display, window on the remote control.
119En