Owner`s manual

INPUT
• Adjusting the balance of the speaker
level in Zone 2 or Zone 3
or
_i) 00O%
(U.S.A. model)
• Select TUNER as the input source to use the TUNER
features in the selected zone. For details about the
TUNER operations, see "FM/AM TUNING" on
page 54.
• Select XM as the input source to use the XM Satellite
Radio features in the selected zone. For details about
the XM Satellite Radio operations, see "XM
SA_I'ELLITE RADIO TUNING" on page 61.
The selectcd input source is shared across all zones.
-#-
Youmust complete this step within 5 seconds while the selected
zone flashes in the fi'ontpanel display. Otherwise, the currently
selectedzone mode is amomatically canceled. In this case, press
ZONE CONTROLS on thefront panel again.
• Adjusting the volume level of Zone 2 or
Zone 3
Rotate VOLUME on the front panel (or press
VOLUME +/- on the remote control) to adjust the
volume level of the selected zone.
or
Press TONE CONTROL repeatedly to select
"BALANCE" and then rotate PROGRAM on the
front panel to adjust the balance of the front left
and right speaker level of the selected zone.
COnTrOL
%-,-
PROGRAM
• Adjusting the tonal quality of Zone 2 or
Zone 3
Set the operation mode selector to AMP and then
press CH +/- on the remote control to adjust the
high-frequency response (TREBLE) or
TV VOL +/- to adjust the low-frequency response
(BASS) respectively.
BASS
TREBLE
Youcan also adjustthe tonal quality of Zone 2 or Zone 3by using
TONE CONTROLon the fl:ontpaneh Fordetails, see "Adjusting
thetonal quality" on page 50.
Note
Check that "ZONE 2" or "ZONE 3" is displayed in the display
windowof the remote conu'olbefore you adjust thetonal quality
of the corresponding zone {seepage 115).
Press MUTE on the remote control to mute the sound output to
the selected zone.
When you use the external amplifiers in Zone 2 or Zone 3,
VOLUME +1- can be used only when ZONE2 VOL" or "ZONE3
VOL" is set to 'WAR" in "ZONE SET" (see page 99).
116 En