Owner`s manual

• You must complete this stepwithin 5 seconds while the
selectedzone flashes in the fl'ontpanel display.Otherwise,
the currently selected zone mode is automatically
canceled. In this case, press ZONE CONTROLS again.
• The initial setting isZONE2 when both Zone 2 and Zone 3
are turned on.
Refer to "Selecting the input source of Zone
2 or Zone 3", "Adjusting the volume level of
Zone 2 or Zone 3", "Adjusting the balance of
the speaker level in Zone 2 or Zone 3" or
"Adjusting the tonal quality of Zone 2 or
Zone 3" on page 116 to perform further
operations.
Remote control operations
Set the operation mode selector to AMP and
then press SELECT A repeatedly to select the
zone you want to control.
"ZONE 2" or "ZONE 3" is displayed in the display
window on the remote control.
_U_E
&
or
Refer to "Selecting the input source of Zone
2 or Zone 3", "Adjusting the volume level of
Zone 2 or Zone 3", "Adjusting the balance of
the speaker level in Zone 2 or Zone 3" or
"Adjusting the tonal quality of Zone 2 or
Zone 3" on page 116 to perform further
operations.
Press SELECT A / V to exit from the
Zone 2/Zone 3 mode.
Noia:
The input source of Zone 2 and the source available fl)r
recording are always the same.
• Turning on or off Zone 2 and/or Zone 3
using the remote control
POWEP. and STANDBY on the remote control work
differently depending on the selected zone that appears in
the display window on the remote control.
• When the main zone, Zone 2 or Zone 3 mode is
selected, you can turn on the main zone, Zone 2 or
Zone 3 or set them to the standby mode individually.
• When the all mode is selected, pressing POWER turns
on the main zone, Zone 2 and Zone 3 simultaneously
and pressing STANDBY sets them to the standby mode
simultaneously.
Turnson themain
Main zone Name ol the setected
mode input area zone only or sets it to
the standb 3, mode.
ZONE 2" or "2;name Turns on Zone 2 or
Zone 2 mode of the selected input sets it to the standby
area" mode.
ZONE 3" or 3;name Tnrns on Zone 3 or
Zone 3 mode ol the selected input sets it to the standby
area" mode.
POWER:turnson
the mainzone,Zone
2 andZone 3.
All mode _'ALL" STANDBY:setsthe
main zone, Zone 2
and Zone3 to the
standby mode.
Natoa
• When the remote control is in the main zone mode, "MAIN"
appears for a few seconds when POWERor STANDBYis
pressed.
• "ALL" appears in the display window on theremote control
only when SELECT _7is pressed.
• Selecting the input source of Zone 2 or
Zone 3
Rotate the INPUT selector on the front panel (or
set the operation mode selector to AMP and then
press one of the input selector buttons on the
remote control) to select the input source of the
selected zone.
If"the remote control is used to select the input source, "2:
name of the selected input source" or "3: name of the
selected input source" is displayed in the display window
on the remote control when Zone 2 or Zone 3 is selected
respectively.
115sn