Owner`s manual

• Using the internal amplifiers of this unit
IMPORTANT SAFETY NOTICE
The SP1 or SP2 speaker terminals of this Receiver should not be connected to a Passive Loudspeaker Selector Box or
more than one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low
impedance load resulting in amplifier damage. See this owner's manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This
information is found on the back panel of your Receive1:
If you want to use one internal amplifier (SP1 or SP2) of this unit
Connect the Zone 2 or Zone 3 speakers directly to the SP1 or SP2 speaker terminals and select either "[SP1]" or "[SP2]"
for "ZONE2 AMP" or "ZONE3 AMP" (see page 100).
If you want to use two internal amplifiers (both SP1 and SP2) of this unit
Connect the Zone 2 or Zone 3 speakers directly to the SP1 and SP2 speaker terminals and select "BOTH" for "ZONE2
AMP" or "ZONE3 AMP" (see page 100).
L
This unit
You can select the zone you want to control by using the
control buttons on the fl'ont panel or on the remote control.
Third room
(Zone 3)
• Selecting Zone 2 or Zone 3
Front panel operations
1 Press ZONE 2 ON/OFF or ZONE 3 ON/OFF on
the front panel to individually turn on or off
Zone 2 or Zone 3.
ZO_EO_FF
Press ZONE CONTROLS on the front panel
repeatedly to select the zone you want to
control.
zo_E Cm_T_L_
%
Each time you press ZONE CONTP, OLS, the front
panel display changes as shown below, and the
indicator for the currently selected zone flashes for
approximately 5 seconds. However, no indicator
flashes when the main zone is selected.
_ ZONE2 _ ZONE3_
\ I/ {--
/ i \
No indicator flashes when the main zone is
selected.
ZONE2
Controls the Zone 2 amplifier or tuner functions.
ZONE3
Conm)ls the Zone 3 amplifier or tuner functions.
114 E,