Owner`s manual

• Clearing a macro function
YOUcan clear the function progrmnmed for a certain
rllacro btltton.
Set the operation mode selector to AMP or
SOURCE and then press MACRO using a
ballpoint pen or similar object.
"MCR ?" appears in the display window on the
remote control.
S_JROE
45
or _ M_
©
N
TV
==:J== ."}ii: ==:::== :5
)
11 you do not complete each ol the lollowing steps within 30
seconds, the macro programming mode will be
automatically canceled. In this case, st}iF[ (),,'el"11"oii)step 1.
Press and hold CLEAR using a ballpoint pen
or similar object, then press the macro
button you want to clear for about 3 seconds.
"C;OK" appears in the display window on the remote
control if clearing was successful.
(U.S.A. mode1)
• If you continuously want to clear another function, repeat
step 2.
• Once you clear a programmed function, the button reverts
to the lhctory setting (or to the manufacturer selling if you
have set remote control codes).
3 Press MACRO again to exit the macro
programming mode.
• "C:NG" appears in thedisplay window on the remote control il
clearing v,as unsuccessfuh 117this case, start met lrom step 2.
• "EI{ROI'U'appears in the display windowon the remote control
if you press more than one button sin)uhaneously.
112 En