Owner`s manual

• Clearing a learned function
YOUcan clear the function learned for a certain button in
eacb control area.
Set the operation mode selector to AMP or
SOURCE and then press an input selector
button or _ to select the input area
containing the function you want to clear.
The selected component tmme appears in the display
window.
S00P_E
or
AMPt!
mUmE
&
6o
PHONOO Q_TUNER (_ MLILTICH INO
V-AUX/DOCK CBDSAT MDffApE CD-R
OO
(U.S.A. model)
Press LEARN using a ballpoint pen or similar
object.
"LEARN" and the selected component name
(ex. "DVD") appear alternately in the display
window.
I
!!!IIEikiIIiiiiiiiiiiiii
• Do not press and hold LEARN. If you hold it down for
more than 3 seconds, theremote control enters the remote
control code setting mode.
• If you do not complete each of the lollowing steps within
30 seconds, the learning mode will be automatically
canceled. In this case, start over li'omstep2.
if_l_.ll_pl.h'ilip]m;l:r_wIw*:l:_
Press and hold CLEAR using a ballpoint pen
or similar object and then press the button
you want to clear for about 3 seconds.
"C;OK" appears in the display window if"clearing
was successful. Once "C;OK" appears in the display
window on the remote control, release the ballpoint
pen or similar object used to press CLEAR to exit the
clearing mode. The remote control returns to the
learning mode.
(U.S.A. model)
• If you continuously want to clear another function, repeat
step 4.
• If you continuously want to clear another function for
another component, press SELECT _ / V to select the
input area, then repeat step4.
• Once youclear a learned function, the button reverts to the
15,ctoryselling (or to the manufacturer setting if you have
set remote control codes).
4 Press LEARN again to exit.
• "C:NG" appears in the display window on the remote control if
clearing was unsuccessfid. In this case, start over from step 2.
• "ERROR" appears in the display window if you press more than
one button simultaneously.
111En