Owner`s manual

II:/:l/_[e) t:EKel;it:relll_:L, ttll:l_€
YOUcan clear all changes made in each flmction set, such
as learned functions, macros, renamed input area names
and setup remote control ID.
• Clearing function sets
Set the operation mode selector to AMP or
SOURCE and then press CLEAR by using a
ballpoint pen or similar object.
"CLEAR" appears in the display window.
SOUmE
&
or
i;;; i_= = ==;;.=
11you do not complete each ol the lollowing steps within 30
seconds, the clearing mode will be aulo.qlatically canceled.
In this case, start o\er lroHt step 1.
2 Press A / _ to select the clear mode.
L:CD (etc.) (L: Name of an input area)
Clears all learned functions in the respective
input re'ca. The name of a component is shown
after a semicolon _ ). Press an input selector
button to select the input area.
LAMP Clears all learned l_mctions for conlrolling the
amplifier functions of this refit.
L;ALL Clears all learned functions.
M;ALL Clears all programmed macros.
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the
remote R)the factory settings.
Press and hold CLEAR again for about 3
seconds.
"WAIT" appears in the display window. If"clearing
was successful, "C;OK" appears in the display
window on the remote control.
ii'=="D_|; |:
i J {
! IJ
Once you ha,,e cleared a learned function for a button, the
button reverts to the factory setting (or to the manulhcmrer
setting, if you have set remote control codes).
• "L;ALL" and "FCTRY" may take about 30 seconds to
complete.
• "C:NG" appears in the display window if clearing was
unsuccessfuh In this case start over from step 2.
• "ERROR" appears in the display window if you press a
button not indicated in the respective step, or if you press
more than one button simultaneously.
110 E,