Owner`s manual

Press/_ / V to select and enter a character.
Pressing V changes the character as follows:
A to Z, 1 to 9, 0, + (plus), (hyphen), ; (semicolon),
/ (slash), and space.
Pressing A changes the characters in reverse order:
_aESeT/_H
4 Press [> to movethe cursor to the next
position.
PRESeT/_H
Press <1 R) move the cursor to the previous position.
Press ENTERto set the new name.
"OK" appears in the display window on the remote
control if renaming was successful.
"NG" appears in the display window on the remote
control if renaming was unsuccessful, in this case,
start over from step 3.
"4:--
If you continuously want to rename another input area, press
the input selector button or v,_,or press SELECT A / V
repeatedly to select the component, then repeat steps 3
through 5.
6 Press RENAME again to exit the renaming
mode.
"ERROR" appears in the display window on the remote control if
you press a button not indicated in the respective step, or when
you press more than one button simultaneously.
"4:--
This ligature is useful when you change the input or o[llpnt
assigmnent for digital jacks and component video input jacks.
Relier to "INPUT RENAME" on page 95.
The macro programming feature makes it possible to
perform a series of operations with the press of a single
button. For example, when you want to play a CD,
normally you would turn on the components, select the
CD input, and press the play button to start playback. The
macro programming feature lets you perform all of these
operations simply by pressing the CD macro button. The
buttons listed as macro buttons below are factory set with
macro programs. You can also progranl your own macros
(see page 109).
• MACRO operations
Macro buttons (U.S.A. model)
MACRO ON/OFF MACRO
1 Set the MACRO ON/OFF selector to ON.
2 Press the desired macro button.
3 Set the MACRO ON/OFF selector to OFF
when you finish to using the macro
programming operation.
Notea:
• While the remote corm'el is rmming a macro program, it does
not accept any other operation until it has completed running
the program (the transmission indicator stops flashing).
• ('ontin{le to ailn the l'ei_Itote control at the component the iHacro
is operating until the macro operation is complete.
107 e.