Owner`s manual

ff_i_pll_pph'ilip]m;l:r:tIw*:l_,
You can program remote control codes from other remote
controls. Use the learn feature if you want to program
functions not included in the basic operations covered by
the remote control codes, or an appropriate remote control
code is not available. You can program the function of
other remote control to the buttons in the highlighted areas
in the following illustration. The buttons can be
programmed independently for each input area.
i!@;!;i@iiiiiiii!@_f@
@00q9
_ r_ r_ r_
(U.S.A. model)
Note
The remote control transmits inl_'arcd rays. If the other remote
control also uses infrared rays, this relllOte control cart learn most
of its functions. However, you may not be ahle to program some
special signals or extremely long transmissions. Refer It) the
operating instructions R)r the other remote controh
Set the operation mode selector to SOURCE
and then press an input selector button or ,,',-
to select an input area.
50
q) q) q)SOURCE
(_) _ V-AUXJDOCK CBUSAT _ID/TAPg: CD-R
& 0000
(U.S.A. model)
iii!i,iBKBiiiiii:i
Make sure that the operation mode selector is set to SOURCE.
When you set the operation mode selector to AMP and program a
remote conu-ol codes from other remote controls, the
programmed key cannot operate the amplifier function of this
unit.
Place this remote control about 5 to 10 cm
(2 to 4 in) apart from the other remote control
on a flat surface so that their infrared
transmitters are aimed at each other.
(U.S.A. model)
f--
o0000
0000
0000
\
Other remote control
5to lOcm (2to 4 in)
Press LEARN using a ballpoint pen or similar
object.
"LEARN" and the name of the selected input area
(ex. "DVD") appear alternately in the display window
on tile remote control.
lip
• Do not press and hold LEARN. lfyou hold it down for
more than 3 seconds, the remote enters the rclltote control
code setting mode.
• If you do not complete each of the following steps within
30 seconds, the learning mode will be automatically
canceled. In this case, start over from step 3.
Press the button for which you want to
program the new function.
"LEARN" appears in the display window on the
remote control.
(U.S.A. model)
J [IiR!i
105 En