Installation guide

M208 Manager
Re:control
5
Working with the M208 Manager
Establish connection/ -Status
Start the M208 Manager. In case that you did not yet
connect the M208 with the PC, you will see the
message “not connected”:
Not Connected means that no connection
between the PC and the M208 has been
established. The M208 has not been recognized by
the PC yet.
Once the connection has been established or the
installation of the USB driver has been completed
the message changes to “Connected”:
Connected (Rx0, Tx0) indicates that you are using
now the M208 Manager for data transfers, whereas
Rx and Tx shows the number of received or sent
bytes.
Status of the connection
Open a project
With Open you can open an existing project
In the second window you will have to choose the
project.
The command Open will open a project. In this
example the project M208 V1.00.mpj was chosen.
L
mpj All project names end with the extension
*.mpj