Technical data

DVD-Modul MK4
Re:source
3
Installation
The DVD plug-in card has the most
modern technology on it and should be
handled with care.
Before you start to install the card, the
M51
must be switched off and the
power plug must be removed from the
power socket.
Slot 3 is reserved for the DVD module,
the third slot from the right viewed
from the back of the unit.
Loosen the two screws with the TORX
screwdriver supplied and remove the
slot blanking plate.
Before removing the DVD module from
its packaging, make sure that you are
not charged with any static electricity.
This could cause a damaging power
discharge when you touch the module.
To be on the safe side, you should
discharge any static from yourself by
touching an earthed metal object such
as a radiator.
Remove the DVD module from its
packaging and insert it into the slot
position, using the two tracks within
the M51 to guide it into position. The
lettering on the card must be at the
top. Just before the card is fully
inserted, you will feel a certain
mechanical resistance as the card
meets the M51 contact strip. Push the
card fully home by pushing in the area
where the 2 screw holes are located
and fix it in place with the two screws.
All further steps needed to integrate
the new module into the M51 will be
carried out automatically next time the
unit is switched on.