Technical data

M219 MK2 Re:connect
6
Front view M219
[A] IR Sensor
The InfraRed sensor receives signals
from the remote control or from any
other IR control devices, such as the
PDAs for the music server.
Switching the IR sensor off
If required, the IR sensor can be
switched off using the SETUP DIL
switch [3] on the rear of the M219.
[B] Status LED
[C] Ventilation slots
The ventilation slots on the front and
the top of the M219 must always be left
clear of obstructions.
The M219 should be installed in such a
way that the ventilation slots are not
covered up and so that there is a gap
of at least 5cm between the unit and
any walls or furniture.
Room-Amplifier
M219
[A] [B] [C]
The blue status LED gives information about the current state of the M219.
LED display M219 Status
Permanently dar
k
M219 standby mode
Permanently lit M219 active
Rapid flashing Breakdown, overload
Rapid flashing Min/max position reached
(Volume, Bass, Treble, Balance)
Slow flashing IR receive (RC5 or RC6 Codes)
Single flash LOCAL 1 or general change of source
Double flash LOCAL 2
Triple flash LOCAL 3