Technical data

M219 MK2 Re:connect
17
[10] R – L SPEAKERS
Speaker connection
Always use a cable of a sufficient
diameter for connecting your speakers
to the M219.
Revox recommends:
up to 15m / 50ft: 1.5 mm
2
/ AWG15
up to 30m / 100ft: 2.5 mm
2
/ AWG13
over 30m / 100ft: 4.0 mm
2
/ AWG11
We recommend not to use cables
longer than 50m, due to the
unavoidable loss of HiFi reproduction.
Each individual speaker must have an
impedance of 4  or higher. You must
ensure that all cable strands are within
the screwable Phoenix connector and
that none of them come into contact
with any adjacent connectors or the
M219 housing.
You will only be assured of a perfect
stage-quality reproduction if you
ensure correct polarity when
connecting. A wrong polarity will not
cause any damage to the speaker or to
the M219, but it can result in imprecise
and diffused reproduction that is weak
in the base ranges.
[11] FUSE
Fuse
Always power the unit down before
replacing the fuse.
When replacing the fuse, always one of
the same type as shown on the M219
rating label.
100-120 V AC: T 1,0A L 250V
200-240 V AC: T 500mA L 250V
Other fuse types with different power,
voltage or operational characteristics
can endanger your life and damage the
unit.
The fuse holder can be removed by
pushing it in slightly and then turning it
in the direction of the arrow.
[12] AC-POWER
Power connection
Only use the Revox power cable
supplied. You must also ensure that the
power supply used delivers the voltage
as shown on the M219 rating label
(120V/ 240V). If required, the M219 can
be modified to work with other
voltages. This modification should only
be carried out by an authorised
specialist.

