User Manual

10
EN
Problem Possible Cause Solution
Boat will not respond to
throttle but responds to other
controls
Throttle channel is reversed Reverse throttle channel on transmitter
Extra noise or extra vibration
Damaged propeller, shaft or motor Replace damaged parts
Propeller is out of balance Balance or replace propeller
Reduced runtime or boat
underpowered
Boat battery charge is low Completely recharge battery
Boat battery is damaged Replace boat battery and follow battery instructions
Blocking or friction on shaft or propeller Disassemble, lubricate and correctly align parts
Boat conditions may be too cold
Make sure the battery is warm (above 10º C [50º F])
before use
Battery capacity may be too low for conditions Replace battery or use a larger capacity battery
Too little lubrication on driveshaft Fully lubricate driveshaft
Vegetation or other obstacles block the propeller Remove vegetation or obstacles from propeller
Boat will not Bind (during
binding) to transmitter
Transmitter is too near boat during binding process
Move powered transmitter a few feet from boat, disconnect
and reconnect battery to boat
Boat or transmitter is too close to large metal object,
wireless source or another transmitter
Move the boat and transmitter to another location and
attempt binding again
Another compatible transmitter in bind mode within
range of the receiver
Power off all compatible transmitters except the one you are
trying to bind
Boat battery/transmitter battery charge is too low Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat will not connect (after
binding) to transmitter
Transmitter is too near boat during connecting
process
Move powered transmitter a few feet from boat, disconnect
and reconnect battery to boat
Boat or transmitter is too close to large metal object,
wireless source or another transmitter
Move boat or transmitter to another location and attempt to
connect again
Boat battery/transmitter battery charge is too low Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat tends to dive in the
water or takes on water
The boat hull is not completely closed
Dry out the boat and ensure the hatch is fully closed on the
hull before returning the boat to the water
Center of gravity is too far forward Move batteries back in the hull
Controls reversed Transmitter settings are reversed
Do the Control Direction Test and adjust controls on
transmitter appropriately
Motor overheats Blocked water cooler lines Clean, unkink or replace water lines
Motor power pulses then
motor loses power
Weather conditions might be too cold Postpone until weather is warmer
Battery is old, worn out or damaged Replace battery
Boat moves forward or
backward without input from
user
Throttle trim on transmitter not centered Adjust throttle trim to center (12 o’clock)
Boat does not drive straight Steering trim on transmitter not centered Adjust steering trim so vehicle drives straight
No steering or lack of
steering
Steering rate not adjusted correctly
Adjusts steering rate (ST RATE) knob on transmitter to
desired steering throw
Servo failed Replace part or contact Horizon Product Support
No throttle or lack of throttle
ESC failed Replace part or contact Horizon Product Support
Motor failed Replace part or contact Horizon Product Support
Troubleshooting Guide