0” self-righting boat RVOS01002T1/T2 Instruction Manual Manuel d’utilisation
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product.
EN Water-Resistant Boat with Waterproof Electronics Your new Horizon Hobby boat has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in calm, fresh water conditions. While the entire boat is highly water-resistant, it is not completely waterproof and your boat should NOT be treated like a submarine.
EN Box Contents • Revolution® Roguewave™ 10” Self-righting Boat • Boat stand • USB Li-Ion Charger • 2.4GHz Transmitter • 4 AA non-rechargeable batteries (for transmitter) Carefully remove the boat, stand, charger, radio transmitter, and AA batteries from the box. Inspect the boat for damage. If your product is damaged, please contact the hobby shop where you purchased your boat, or contact Horizon Hobby Product Support. Refer to the Warranty and Service Contact Information section for more info.
EN Low Voltage Cutoff (LVC) Discharging a Li-Ion battery below 3V per cell may damage your battery. The included ESC protects the boat battery from overdischarge using Low Voltage Cutoff (LVC). Before the battery charge decreases too much, LVC removes power supplied to the motor. Power to the motor pulses, showing that some battery power is reserved for boat control and safe landing. Disconnect and remove the Li-Ion battery from the boat after use to prevent trickle discharge.
EN Transmitter DUAL FUNCTION SWITCH STEERING TRIM Allows you to adjust the steering trim to ensure the boat tracks straight. Adjust the servo angle by turning the switch up or down. Turn the switch up for a larger servo angle and down for a smaller servo angle. STEERING WHEEL Controls steering. Right and Left steering with ST. REV Switch on N (see ST. REV switch). REVERSE SWITCHES Allows you to change the direction of steering (ST. REV) and throttle (TH. REV) controls.
EN Getting Started IMPORTANT: Perform a control check at the beginning of each boating session, after repair or after installation of new batteries. 1 1. Power on the transmitter. 2. Connect the battery connector to the ESC power connector. 3. Test the transmitter’s steering and throttle control of the boat with the boat on the display stand. NOTICE: Do not operate the motor without water cooling circulation or damage may result. 2 Ah 360m ery 7.
EN Self-Righting Feature the weight loose. If the weight comes loose, glue the weight back in place inside of the ballast. The weight must be placed 60mm forward as measured from the back of the boat. It is normal to have the boat list to the left side when you place the boat in water. This is a natural effect of the built-in water ballast, which helps the boat self-right when upside down.
EN Rudder and Propeller Service Rudder 1. Disconnect the servo linkage (A) from the arm (B) of the rudder (C). 2. Remove the two screws (D) from the rudder mount (E) and remove the rudder assembly. 3. To remove the rudder from the mount, tap the hinge pin (F) through the holes in the rudder and mount. 4. Assemble in reverse order. E A F D H Propeller I 1. Use the included wrench to loosen the nut (G) from the drive shaft (H). To secure the propeller (I) while loosening the nut, hold the propeller. 2.
EN Troubleshooting Guide Problem Boat will not respond to throttle but responds to other controls Extra noise or extra vibration Reduced runtime or boat underpowered Boat will not Bind (during binding) to transmitter Possible Cause Solution Throttle channel is reversed Reverse throttle channel on transmitter Damaged propeller, shaft or motor Propeller is out of balance Boat battery charge is low Boat battery is damaged Blocking or friction on shaft or propeller Battery capacity may be too low for co
EN Limited Warranty Inspection or Services If this Product needs to be inspected or serviced and is compliant in the country you live and use the Product in, please use the Horizon Online Service Request submission process found on our website or call Horizon to obtain a Return Merchandise Authorization (RMA) number. Pack the Product securely using a shipping carton. Please note that original boxes may be included, but are not designed to withstand the rigors of shipping without additional protection.
EN Warranty and Service Contact Information Country of Purchase Horizon Hobby Contact Information Horizon Service Center (Repairs and Repair Requests) servicecenter.horizonhobby.com/ RequestForm/ Horizon Product Support (Product Technical Assistance) North America Sales productsupport@ horizonhobby.com Address 4105 Fieldstone Rd Champaign, Illinois, 61822 USA 877-504-0233 websales@horizonhobby.
©2018 Horizon Hobby, LLC. Revolution, the Revolution logo, Roguewave, Dynamite, and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. All other trademarks, service marks or logos are property of their respective owners. Patents pending. Created 1/18 56972.
