User Manual

Control Test

1. Turn the aircraft and transmitter on.

2. Arm the aircraft.

3. Move the sticks on the transmitter to ensure the

aircraft responds as shown.

4. Note the corresponding  ight direction to control

surface movement.

5. If surfaces do not move as expected, DO NOT  y.

See the troubleshooting section in the back of

this manual.

Transmitter Control Surface Flight Direction

Turn left

Rudder left

Rudder Right

Elevator Down

Elevator Up

Turn Right

Nose Down

Nose Up

Binding

If your aircraft does not respond to the transmitter when the batteries in the aircraft and transmitter are fully

charged, bind your aircraft and transmitter by using the instructions below.

1. Turn off the aircraft by  rst disconnecting the  ight battery from the aircraft and then powering off the

transmitter.

2. Make sure your transmitter’s controls are neutral, and the throttle is in the off position (0%).

3. Power on the transmitter. The red LED will start  ashing indicating the transmitter is in Bind mode.

4. Connect the  ight battery to the aircraft.

5. Hold the transmitter more than 24 inches (60 cm) away from the aircraft. Keep away from large metal

objects, wireless sources and other transmitters.

6. Move the throttle stick from power off (0%) to full throttle (100%) and back to power off. The red LED will

change from  ashing to solid when the Bind is complete.

7. Once the Bind is complete you will have control of the aircraft.